I'm trying install hashcat on a fresh ubuntu 18.04 installation. I'm using an AMD Radeon RX 570. Both my desktop monitors are connected to the GPU (not sure if that matters or makes a difference).
Immediately after installing Ubuntu, I updated:
Then began following the install instructions as per the hashcat FAQ:
Then I downloaded what I think is the correct driver:
Unpacked it and ran the following:
No installation errors reported. I ran it again for this forum post, here's the output:
Then rebooted again.
Then rebooted again. Using `clinfo` only reports 1 platform and its my CPU. After downloading hashcat and unpacking it, I ran it with:
But hashcat only uses the CPU. Looking again at the FAQ, I tried the `amdconfig` command but its not found.
Where did I go wrong? I could really use some help.
Immediately after installing Ubuntu, I updated:
Code:
$ apt-get update && apt-get dist-upgrade && rebootThen began following the install instructions as per the hashcat FAQ:
Code:
$ sudo find / -name libOpenCL\* -print0 | xargs -0 rm -rf && rebootCode:
$ sudo apt-get install ocl-icd-libopencl1 opencl-headers clinfo && rebootThen I downloaded what I think is the correct driver:
Code:
$ wget https://www2.ati.com/drivers/linux/ubuntu/18.04/amdgpu-pro-18.20-606296.tar.xzUnpacked it and ran the following:
Code:
$ ./amdgpu-install --version="1.6.180"No installation errors reported. I ran it again for this forum post, here's the output:
Code:
Reading package lists... Done
Building dependency tree
Reading state information... Done
amdgpu is already the newest version (18.20-606296).
amdgpu-lib32 is already the newest version (18.20-606296).
0 upgraded, 0 newly installed, 0 to remove and 1 not upgraded.Then rebooted again.
Code:
$ sudo mv ~/.hashcat/kernels /tmp/old_kernelsThen rebooted again. Using `clinfo` only reports 1 platform and its my CPU. After downloading hashcat and unpacking it, I ran it with:
Code:
$ ./hashcat64.bin -b -m2500But hashcat only uses the CPU. Looking again at the FAQ, I tried the `amdconfig` command but its not found.
Code:
$ amdconfig --adapter=all --initial -f
amdconfig: command not foundWhere did I go wrong? I could really use some help.