Hi all. Tried searching but no one seemed to ask this question so here it is:
I was trying a custom markov from a dictionary (e.g. linkedin) and ran statsprocessor.
Is there a speed difference between piping in Windows or in Linux? I am roughly getting 80k tries on Windows (which was relatively slower than dictionary) so I'm wondering if it's a Windows thing or it's about the same number of attempts in Linux/*nix as well?
Also, would it boost up the speed more if you just store the output of statsprocessor into a file and run it as a dict in the end (assuming a decent amount of HDD capacity with a limited threshold and length)? Or in totality the amount of time you need to save sp output to a file will end up as the same as piping it to oclhashcat directly?
Pardon the noob questions, and thanks for your time
I was trying a custom markov from a dictionary (e.g. linkedin) and ran statsprocessor.
Is there a speed difference between piping in Windows or in Linux? I am roughly getting 80k tries on Windows (which was relatively slower than dictionary) so I'm wondering if it's a Windows thing or it's about the same number of attempts in Linux/*nix as well?
Also, would it boost up the speed more if you just store the output of statsprocessor into a file and run it as a dict in the end (assuming a decent amount of HDD capacity with a limited threshold and length)? Or in totality the amount of time you need to save sp output to a file will end up as the same as piping it to oclhashcat directly?
Pardon the noob questions, and thanks for your time